Hp Sensor Replacing - SNBC BTP-M300 Service Manual

5) 5 Remove e the two ST
6) 6 Install a a new lower
Caut tion:
When the lower m
the lowe er mark sens
While d isassemblin
cover of f printer;
Please do not drag
breaking g the cable c
Please make sure a
Please avoid squee
During r reassemblin
5.1.8 HP sen 5 nsor replac
1) 1 Turn off f the power.
2) 2 Disasse emble the tra
3) 3 Remove e the one S
figure.
4) 4 Install a a new HP se
T2.2X4 screw ws with cros
mark senso or in the reve
mark sensor is fixed at p
sor is fixed a at position ②
ng the lockin ng frame of
g the conne cting cable
connector;
all the cable s connect to
ezing the ca ble in reasse
ng, please fix x all screws
cing
ansmission module acc
ST2.9X6 with h cross scre
ensor in the r reverse step
ss screwdriv ver and disa
erse steps.
position ① , p please repla
, pleas se skip over
②③④
printer, the f force must b
while pullin g the cable
o their socke ets firmly;
embly;
firmly.
ording to the e step 2, 3, 4
ewdriver an d disassem
ps.
- 32 -
BT P-M300 Ser
ssemble the e lower mark
ce the sens sor in above
r the step 4 above.
be moderate e to avoid d
out of main n control bo
4 and 5 in s ection 4.2.5
ble the HP sensor as s
rvice Manu al
k sensor;
steps; whe n
damaging th e
oard to avoid d
5.
shown in th he