Disassemble The Stationary Blade Cutter Module - SNBC BTP-M300 Service Manual

4.2.3 Disassemble the stationary blade cutter module

Picture
Remove the three screws (M3x5) shown in the
figure with cross screwdriver and take off the
interface plate in the arrow direction shown in the
figure.
Take off the one "E"-ring on one end of the rotation
shaft of stationary blade cutter with sharp-nose
pliers, pull out the rotation shaft of stationary blade
along the arrow direction and disassemble the
stationary blade module
Remove the two screws (M3x7) shown in the
figure with cross screwdriver, and take off the
cutter bracket and stationary blade cutter
Notes:
Please be careful to keep the stationary blade
disassembled to avoid damage to human
body;
Please be careful to keep the stationary blade
disassembled to avoid being scratched by
hard objects.
- 14 -
BTP-M300 Service Manual
Instructions