Table of Contents
Advertisement
10.3 Transport to Working Position
Before operating the windrower, the windrower needs to be set to the working position. Follow the following
procedure:
Before putting the rock windrower into working position, be sure that the drum is locked into
transport position. Refer to the transportation section of this manual for complete drum lock
up instructions.
•
Raise wheel lock pins to the temporary
position.
•
Remove the wedge lock from the transport
cradle.
•
Store the wedge lock in the holder on the hitch
pole.
•
Drive the tractor ahead while turning the wheels
to the right.
•
Pivot the windrower until the hitch pole fits
securely into the working cradle.
SRW1400 08/16
© 2016 Alamo Group Inc.
OPERATION
Operation Section 4-21
A-Transport cradle
B-Working cradle
C-Wheel lock pins
D-Gearbox output driveline
Advertisement
Table of Contents
