Table of Contents
Advertisement
•
Lower the wheel lock pins into the pivoting
wheel assembly.
•
Install the wedge lock into the working cradle.
Note: The flat edge of the wedge lock should be
against the hitch pole.
•
Remove output driveline from storage location.
•
Connect the output driveline to the gearbox.
•
Push and pull on the quick disconnect yoke
several times to ensure that the yoke is
connected to the gearbox shaft.
•
Move the transport wheel lock pin into working
hole.
•
Raise the transport wheel.
•
Reinstall the transport wheel lock pin.
•
Remove the drum transport lock pin.
•
Store the drum transport lock pin in the storage
hole on the main frame.
Once unit has been set to working position, start off driving at a slow speed and gradually increase your speed
while maintaining complete control of the tractor and windrower. Moving slowly at first will also prevent the
tractor from rearing up and loss of steering control. The tractor should never be operated at speeds that cannot
be safely handled or which will prevent the operator from stopping quickly during an emergency. If the power
steering or engine ceases operating, stop the tractor immediately as the tractor will be difficult to control.
SRW1400 08/16
© 2016 Alamo Group Inc.
OPERATION
Operation Section 4-22
Advertisement
Table of Contents
