Table of Contents
Advertisement
Wiring Harness
1. Feed a length of wire through the hitch pole
where the wiring harness will go.
2. Fasten the wiring harness to the wire at the
front end of the hitch pole.
3. Gently pull the wiring harness through the hitch
pole. You may need to loosen the hydraulic line
mountings to facilitate this.
4. The wiring harness should enter the hitch pole
as shown in Figure Asm-W-0012 and exit as
shown in Figure Asm-W-0013.
5. The short leg of the wiring harness should go to
the lights on the right side of the machine. Plug
the wiring harness into lights following the color
coding on the wiring harness.
6. Ensure that the wiring harness will not limit the
machine's range of movement and use the wire
ties provided to secure the wiring harness. Use
Figures Asm-W-0010 through Asm-W-0013
as a guide for final placement of the wiring
harness and the wire ties.
SRW1400 08/16
© 2016 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-6
Advertisement
Table of Contents
