Schulte SRW1400 Operator's Manual page 17

Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
Perform service, repairs and lubrication according to the maintenance section. Ensure the
unit is properly lubricated as specified in the lubrication schedule and all bolts and nuts are
properly torqued. Failure to properly service, repair and maintain this Implement in good
operating condition could cause component failure and possible serious injury or even
death.
Schulte Products use balanced and matched system components for blade carriers, blades, cuttershafts,
knives, knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested to
Schulte Industry specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The
use of "will fit" parts may reduce the performance, void Schulte warranties, and present a safety hazard. Use
genuine Schulte parts for economy and safety.
Always disconnect the auxiliary hydraulic couplers from the Power Unit before performing
service on the Implement. Never work on the Implement with the Power Unit auxiliary
hydraulics connected. Rotating parts such as blades could turn without warning and cause
immediate entanglement, injury or death.
Ensure any remote starting system is inoperative before servicing or cleaning the machine.
Inadvertent engine start up could result in entanglement or runover causing serious injuries
or death.
Never crawl under a raised Implement supported solely by the Tractor 3-Point hitch.
Release of the control lever or mechanical failure will result in the Implement falling and
possible injury or death.
underneath to perform repairs and service.
SRW1400 08/16
© 2016 Alamo Group Inc.
SAFETY
(SG-35)
PARTS INFORMATION
(SPSI-1)
SEE YOUR SCHULTE DEALER
(SSB-17)
Always securely block up the Implement before crawling
Safety Section 1-11
(SG-21)
(SPU-31)
(S3PT-19)