Procedure To Switch From Course Control Mode To Heading Control Mode; Table 20 Procedure To Switch From Course Control Mode To Heading Control Mode - Raytheon Anschütz NautoPilot 5000 Series Operator's Manual

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Please note:
- If there is no automatic switchover to Heading Control (in the event of a wrong or
- It is necessary to observe the Autopilot control function after activation.
- For heading changes in Heading Control mode, see section 4.3.6.
4.3.3

Procedure to switch from Course Control mode to Heading Control mode

Table 20
Please note:
- After switching over, the actual heading from Course Control mode will become the
- It is necessary to observe the Autopilot control function after activation.
10000001052
corrupted configuration) it is strongly advised that the operator presses the
Heading Control button.
Procedure to switch from Course Control mode to Heading Control Mode
Course Control mode is active.
The mode is displayed at the top right corner of the display
(Course Ctrl.).
Pressing the Heading button activates Heading Control
mode.
The mode change is displayed at the top right corner of the
display (Course Ctrl. → Heading Ctrl.).
For heading changes in Heading Control mode, see
section 4.3.6.
set heading in Heading Control mode.
106
Edition: 003