Raytheon Anschütz NautoPilot 5000 Series Operator's Manual page 136

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Set Course Over Ground
Caution!
Course Approaching is displayed at the top bar of the display.
Rotary knob is disabled and a new set course over ground input is not
possible while the heading change maneuver is running.
If set course over ground value is reached the caution Course Approaching is
no longer displayed. Now it is possible to make a new course change
maneuver.
Please note:
- It is necessary to observe the Autopilot control function after heading change.
10000001052
Turning the rotary knob will change the set Course Over
Ground value.
Please note: After approx. 15 seconds of inactivity from
the rotary knob, the previous Course Over Ground value
Preselected COG
is displayed again.
125.8
This value is displayed in italic and inverted colors.
The SET LED (near the button) is flashing (request to
press the SET button).
Pressing the rotary knob transmits the preselected value
to the controller as the new Set Course Over Ground.
The value is now displayed in non- italics and normal
colors.
125.8
The SET LED (near the button) is off.
120
Edition: 003