Raytheon Anschütz NautoPilot 5000 Series Operator's Manual page 80

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Figure 30/11 For Adaptive mode only and not for NP 5100.
Figure 30/12 Softkey for changing/entering the counter rudder parameter (see
Figure 30/13 Softkey for changing/entering the rudder parameter (see also
Figure 30/14 Softkey for changing/entering the yawing parameter (see also
Figure 30/15 Heading (waypoint) change mark; designates the point on the
Figure 30/16 Display with graphic information on Track and Distance to course-
10000001052
Softkey for changing/entering the ship load condition
parameter (see also section 1.3.4). Value range: 10% to 100% (in
increments of 10%).
Use the + and - softkeys to make a change.
Changes must be acknowledged with SET (a small icon is
displayed after a change has been made, see Figure 31).
also section 1.3.3). Value range: 0 to 9 (in increments of 1) .
Use the + and - softkeys to make a change.
Changes must be acknowledged with SET (a small icon is
displayed after a change has been made, see Figure 31).
section 1.3.2). Value range: 1 to 9 (in increments of 1).
Use the + and - softkeys to make a change.
Changes must be acknowledged with SET (a small icon is
displayed after a change has been made, see Figure 31).
section 1.3.1). Value range: 1 to 6 (in increments of 1).
Use the + and - softkeys to make a change.
Changes must be acknowledged with SET (a small icon is
displayed after a change has been made, see Figure 31).
course line (track) when a heading change is commanded or a
new waypoint is piloted.
line (track).
The distance between 2 dotted horizontal lines marks the time
difference of one minute.
64
Function
Edition: 003