Raytheon Anschütz NautoPilot 5000 Series Operator's Manual page 130

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Speed source
Speed value
Position source
Position value
Rudder limit
RAD/RoT
Course Trim
Heading monitor
Track Limit
OFF Position Limit Adjust Limit threshold for deviation between first and
Alarm/Status
10000001052
Check
The desired speed source is shown and can be adjusted
via the Page function:
Softkeys Page→Value→Speed (see
also section 2.3.6.2 and Figure 50)
The speed value must be valid.
If speed value is invalid, select Manual Speed.
(see also section 2.3.6.2 and Figure 50)
If only one position sensor is available, and no speed
source is available, it is not possible to activate Course
Control (see also section 2.3.5.5).
The position value must be valid.
If no position sensor is available, it is not possible to
activate Course Control (see also section 2.3.5.5).
Adjust rudder limit according to sea area and weather
conditions.
Softkeys Limit → Limit Page
(see also section 2.3.6.4)
Adjust RAD/RoT values to be less than the ship's maxi-
mum values.
Softkey Rad / RoT
(see also sections 2.3 and 2.3.6.3)
Adjust Course Trim threshold for deviation from Set
Course Over Ground.
Softkeys Limit → Limit Page
(see also section 1.3.7 and 2.3.6.4)
Adjust Heading Monitor threshold according to traffic in
sea area; the more traffic, the smaller the threshold.
Softkeys Limit → Limit Page
(see also section 2.3.6.4)
Adjust Track Limit threshold according to traffic in sea
area; the more traffic, the smaller the threshold.
Softkeys Limit → Limit Page
(see also section 2.3.5.2 and 2.3.6.4)
second position sensor, e.g. position sensor and dead
reckoning.
Softkeys Limit → Limit Page
(see also section 2.3.5.5 and 2.3.6.4)
The alarm, warning and status bar (top bar of the display)
should not be red/yellowish orange in color.
The cause of alerts should be resolved.
Alerts should be acknowledged.
Comment
114
Edition: 003