Adjust Wrapping Unit - Weber Geset 125 Original User Manual

Chapter 7 Adjustment and initial operation
Step
4
5
6

Adjust wrapping unit

The cylindrical products are labeled in throughput onto its surface by the wrapping unit.
The wrapping unit rotates with a constant speed that is faster than the basic speed.
Information on adjustment of wrapping unit
The wrapping unit will be adjusted to the product by the height adjustment (s. page 38)
that the product will be detected reliably. The product may not be crushed. The lateral
adjustment positions of the wrapping unit has to be as centrally as possible to the label.
No.
1
2
3
4
5
Version: 30.07.14
Procedure
Adjust the side guidance (Pos. 3, Fig. 7-5) to the required criteria (s. section
above). Observe a distance of 1 - 1,5 mm to the product. (In infeed passage
this distance can be adjusted larger).
Tighten the star grips.
Check the adjustment by moving a sample product through the side
guidances. The sample product has to slide easily through the guidance at
each passage.
Description
CRANK FOR HEIGHT ADJUSTMENT OF WRAPPING UNIT
CLAMPING LEVER FOR HEIGHT ADJUSTMENT
CRANK FOR LATERAL ADJUSTMENT OF THE WRAPPING UNIT
CLAMPING LEVER FOR LATERAL ADJUSTMENT
WRAPPING UNIT
Page 38 of 57
40001136 Geset 125
Fig. 7-6: Wrapping unit
GB