Adjustment And Initial Operation - Weber Geset 125 Original User Manual

Chapter 7 Adjustment and initial operation

Adjustment and initial operation

The labeling system has to be re-adjusted at initial operation or at a product change . The
adjustments comprise two functions, operation of the controller (refer to manual of the
labeler) and mechanical setup of the assembly groups (explained in the following).
In following adjustment table all required working steps are listed including adjustments of
optional assembly groups which can be skipped if nonexistent. Experienced operators
may use the adjustment tables later on as a checklist.
Requirements
¥
Control about product transport.
¥
One or more sample products.
¥
Labeling system is connected to power. Triggering of the labeling system is
possible by product sensor or I/O-interface.
Instruction
Please put the labeling system Geset 125 into operation as follows.
Step
1
2
3
4
5
6
7
Version: 30.07.14
Procedure
If there are already exist notes of the „adjustment values" for the product to
be labeled, the values should be available.
Adjust roll conveyor (s. from page 36)
Adjust side guidance (s. from page 37)
Adjust wrapping unit (s. from page 38)
Insert label roll in the labeler (s. from page 39)
Adjust product light barrier (s. from page 39)
Adjust peeler plate (s. from page 41)
Page 35 of 57
40001136 Geset 125
GB