Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Adjust base conveyor
The base conveyor transports the product to be labeled from infeed passage to labeler
and from labeler to outfeed passage.
Information on adjustment of base conveyor's height
The height of the base conveyor has to be adapted to the customer-specific conveyor
system or to the ergonomic requirements of the operator personnel accordingly.
The base conveyor (Pos. 1, Fig. 7-1) is installed fix. The height of the base conveyor can
be adjusted by the threads at the rubber feet (Pos. 4, Fig. 7-1). Adjust the base conveyor
horizontally by an air level.
No.
1
2
3
Requirements
¥
Power supply is turned off.
¥
No transportation of products.
Required equipment
¥
Screw wrench (for rubber feet adjustment)
¥
Air level
Instruction
Please adjust the height of the base conveyor as follows.
Step
1
2
Version: 12.05.14
Description
BASE CONVEYOR
CONNECTION PLATE
SCREWS TO CONNECTION PLATE
Procedure
Crushing hazard! After loosening the connection plate, there exists the
hazard of shafting of the base conveyor. Maintain a distance from base
conveyor.
Loosen the screws to connection plate so that the base conveyor does not
fall down due to its own weight but that an adjustment of the base conveyor
is still necessary. If applicable support the base conveyor with a suitable
device.
Adjust the height of the base conveyor to the required criteria (s. section
above).
Page 32 of 56
40001684 Geset 111
Fig. 7-1: Base conveyor
GB
Advertisement
Table of Contents
