Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Instruction
Please adjust the peeler plate as follows.
Step
1
2
3
4
5
6
Version: 30.07.14
Procedure
Add a product at the infeed passage of the labeling system.
Entanglement hazard! Hazard from actively triggered movements. Maintain
a distance from moved parts.
Just start the roll conveyor and then stop it when the product is in the area of
the peeler plate.
Adjust with the crank for height adjustment (Pos. 1, Fig. 7-8) the distance to
the peeler plate to the required criteria (s. section above). Information on
positioning equipment see from page 33 on.
Loosen the clamping (Pos. 2, Fig. 7-8) of the labeler and adjust the angle of
the peeler plate according to the required criteria (information see above).
Adjust the lateral position of the peeler plate to the product by crank (Pos. 3,
Fig. 7-8). Information on positioning equipment see from page 33.
Add more products separately at the infeed passage to check the
adjustment.
Page 42 of 57
40001136 Geset 125
GB
Advertisement
Table of Contents
