Table of Contents
Advertisement
Chapter 1 General information
Term
Label size
Labeling system
Labeling operation
Labeling system
LED
Low label prewarning Low
label warning
Opacity
Outfeed
Peeler plate
PLC
Poti/potentiometer
Product detector
PSI
Pusher Roller
RFID
RFID label
Service unit
Start sensor
Touchscreen
Trigger signal
VAC
Version: 30.07.14
Explanation
Dictates the label format: Width x length (in the direction of feed
of the label liner measured in millimeters [mm]).
Dispensing system for automatically applying labels
This is the same as automatic mode. The labeling system is
ready to print and dispense labels.
The labeling system is used to label products automatically and
consists of several components (assembly groups), e.g. conveyor
belt, labeling system.
The abbreviation of light-emitting diode
An optical sensor (reflective light sensor) for detection of an
(adjustable) minimum label roll diameter to provide a warning
The transparency of a material can be measured by a light barrier
and is named opacity. The measuring sets the quantity of the
radiated light in proportion to the incoming light. The lower the
proportion, the lower is the opacity.
The outfeed forwards the products to the customer's conveying
system. Here the products are removed.
Metal plate about which the label is peeled off.
Programmable logic controller.
Changeable resistor (controller) for the analog control of labeling
system settings (such as the timing of the tamp movement in
relation to the rotary position of the potentiometer).
A sensor for detecting the product. Most frequently, optical
sensors are used (photocells, light barriers, reflective sensors).
American
unit
of
(1 PSI = 0.06895 bar).
Pushes the label onto the product strongly sticking.
This abbreviation stands for radio frequency identification. This
technology is used to identify products so that they can be
tracked using smart labels (see RFID label ).
The RFID label or also called Smart label is a particular label that
has a transponder onto which data can be written or read via
radio. The identification of products labeled in this way is possible
contactless by an antenna.
This unit consists of:
A gauge for displaying the compression of
the compressed air (in bar)
Quick action stop valve
Water
condensate
See also "Product detector". The start sensor scans the leading
edge of the product. As soon as a product is detected, the
labeling procedure starts. The label position on the product is
adjusted by the sensor position.
Touch-controlled screen or monitor
The signal from the sensor or PLC which is used to activate
application.
Alternating voltage
Page 9 of 57
40001136 BTA Geset 125
measure
for
compressed
trap
for
manually
air.
draining
any
GB
Advertisement
Table of Contents
