Weber Geset 125 Original User Manual page 55

Chapter 10 Troubleshooting
The label is beveled on the product.
Correct the labeling result as follows:
Step
1
The label position changes from product to product.
Correct the labeling result as follows:
Step
1
2
3
4
5
Version: 30.07.14
Procedure
The inclination of the peeler plate may be adjusted incorrectly. Examine and
correct the inclination of the peeler plate.
Procedure
The application speed of the label may be too high or too low. Correct the
application speed of the label
Examine and correct the sensor for product detection.
Examine and correct the distance from peeler bar to product.
Examine and correct the stop sensor of the labeler.
The start delay time may be too short or too long. Correct the entry of the
start delay time of the labeler in HMI.
Page 55 of 57
Fig. 10-3: Product with beveled label
Fig. 10-4: Product with position displacement of the label
40001136 Geset 125
GB