Draining Product From Freezer - ELECTRO FREEZE Compact Series Operator's Manual

ELECTRO FREEZE Shake Model CS705
9.2

Draining Product from Freezer

28
NOTE: It is your responsibility to be aware
of and conform to the requirements for
meeting local, state, and federal laws
concerning the frequency of cleaning and
sanitizing the freezer.
To remove frozen product from the cylin-
der, perform the following steps:
1. Remove the flex shaft cover.
CAUTION
To avoid contact with moving parts,
deactivate spinner by removing flex
shaft cover. Spinner will not operate
with cover removed.
2. Place the selector switch in
the "CLEAN" position.
3. Place a clean, sanitized container
under the dispensing nozzle on the drip
tray.
4. Remove the mix feed tube from the
hopper. (See figure 9-3).
5. Disconnect the syrup lines.
6. Twist and pull down the mixing
chamber removing it from the head.
7. Disconnect the mixer shaft by
releasing the coupling while pulling on the
bottom.
8. Take parts to sink.
9. Place a clean, sanitized container
under the dispensing nozzle on the drip
tray. Dispense the product until the mix is
removed. Close the plunger. Place the
selector and syrup switches to "OFF" and
continue dispensing product until it quits
flowing and . If local health codes permit,
cover the rerun product container and
place it in the cooler. (See 10.2 General
Information - Rerun).
10. Pour 2 gallons of cold water into
the hopper. Place the selector switch to
"CLEAN" and dispense the cold water.
Important:
DO NOT use hot water. Damage to the
freezer could occur.
11. Follow with 2 gallons of warm
water and repeat until the freezer dis-
penses clear water. With most of the water
dispensed, place selector switch in the
"OFF" position and drain off remaining
water.
12. Prepare 2 gallons (7.6 liters) of
sanitizing solution in a container. Sanitizing
solution must be mixed according to
manufacturer's instructions to yield 100
ppm available chlorine solution (example:
Stera-Sheen Green Label).
13. Pour all the sanitizing solution into
the hopper pan. Using a clean brush scrub
the hopper walls.
14. Place the selector switch to the
"CLEAN" position and allow the beater to
run for 5 minutes.
15. Place an empty container under
the dispensing head. Drain the sanitizing
solution from the cylinder by slowly pulling
down on the dispense handle. Open and
close the handle several times while
draining.
16. With most of the sanitizing solution
drained, Place the selector switch to the
"OFF" position and drain remaining solu-
tion from the freezer and close the plunger.
17. Proceed to sections 6 DISASSEM-
BLY AND CLEANING, 7 ASSEMBLY AND 8
STARTUP INSTRUCTIONS.
Tube-Mix
Feed
O-Ring
Figure 9-3
O-Ring
Insert-Assy.
Mix Feed
184592