ELECTRO FREEZE Compact Series Operator's Manual page 31

ELECTRO FREEZE Shake Model CS705
7 Assembly
Figure 7-5 Head Bushing
184592
— continued
6. See figure 7-4 and o-ring chart in
the replacement parts section of this
manual. Install the head o-ring (2) into the
groove on the back of the dispense head
(5),
7. (Install the o-rings (17, 18) on the
plunger (14). Lubricate the o-rings.
8. Install the o-rings (12) onto the
pivot post (13). Lubricate o-rings lightly.
Insert pivot post into the head so the holes
are toward the back.
9. Install the mixer shaft bushing (15)
into the plunger (14).
10. Install the plunger (14) into the
head (5) just past the top o-ring with the slot
facing back. Turn slot slightly to the left and
hook handle (11) into the slot. With handle
in the slot turn the slot to the back.
11. Place the keeper (4) through the
handle (11), pivot post (13) and head (5)
until it locks in place.
12. Lubricate the inside surface of the
beater bearing bushing (3) and place in the
head (5) making sure to align bushing key
into head slot, as shown in figure 7-5.
Important:
Match the key on the bushing. Make
sure the key aligns with the slot. Failure
to install the bushing properly in the
dispensing head will damage the head.
13. Install the dispensing head onto
the freezer by tilting the top of the head
towards you, aligning the studs with the
holes in the head, and sliding toward the
freezer. As you push the head towards the
freezer, carefully rock it into place, and
align the shaft with the drive coupling.
14. Tighten the hand knobs simulta-
neously, finger-tight only.
Important:
Excessive force will damage the head.
Do not use tools to tighten.
15. Insert mixing shaft (8) into the
bottom of the head (5) with mixer paddle
towards the bottom. Pull back the sleeve
on the end of the flexible spinner tube in
the switch box and insert mixing shaft into
tube, turning until it snaps into place.
16. Install the o-ring (10) by pushing it
into groove in the mixing chamber (9).
Lightly lubricate the o-ring. Install the mix
chamber on to the bottom of the head by
placing over bolts and turn to lock in place.
17. Install the actuator rod (16) by
placing one end into hole in the bottom of
the switch box and the other end in the
indent in the plunger behind the flex shaft.
18. Place flex shaft cover (1) on top of
head using bolts to lock in place.
Important:
The freezer will not dispense product
without the flex shaft cover in place.
19. Install the five o-rings (7) on quick
connect fittings (6) on the mix chamber.
Lighly lubricate o-rings..
20. Push each syrup line quick con-
nect (6) onto fitting of the mixing chamber
—continued
21