ELECTRO FREEZE Compact Series Operator's Manual page 51

13 Troubleshooting Charts
PROBLEM
Product 1. No product in hopper.
dispenses
slowly out of
2. Product too cold.
dispensing
head.
Dispensed 1.
product too
hard.
2.
Freezer runs 1.
continually and
product
2.
continues to get
colder.
3.
4.
Compressor 1. Plunger switch defective or out of
and beater adjustment.
motor do not
2. Time delay defective.
operate when
dispensing.
Compressor 1. Plunger switch defective or out of
motor does adjustment.
not operate
2. Time delay defective.
when
dispensing.
3. Defective torque control.
184592
PROBABLE CAUSE
Torque control erratic or set too firm
Low suction pressure, refrigeration
system.
Plunger not fully closed.
Starter or relay contact points stuck.
Torque control not set properly or faulty.
Suction pressure too low.
ELECTRO FREEZE Shake Model CS705
— continued
1. Fill hopper.
2. See "Dispensed product too hard."
1. Contact your Electro Freeze distributor for
service.
2. Contact your Electro Freeze distributor for
service.
1. Close plunger completely.
2. Contact your Electro Freeze Distributor for
service.
3. Contact your Electro Freeze Distributor for
service.
4. Contact your Electro Freeze Distributor for
service.
1. Contact your Electro Freeze Distributor for
service.
2. Contact your Electro Freeze Distributor for
service.
1. Contact your Electro Freeze Distributor for
service.
2. Contact your Electro Freeze Distributor for
service.
3. Contact your Electro Freeze Distributor for
service.
REMEDY
41