ELECTRO FREEZE Compact Series Operator's Manual page 28

ELECTRO FREEZE Shake Model CS705
6.3 Cleaning Instructions
Figure 6-7 Clean shaft seal and plunger
Figure 6-8 Clean scraper blades
Figure 6-9 Clean hopper and mix feed
port
18
— continued
place them in the sanitizing solution. For
proper sanitizing, all parts must remain
fully immersed in the sanitizer for 5
minutes. Allow parts to air-dry after sanitiz-
ing.
Do not leave parts in sanitizer for more
than 15 minutes.
surfaces on the freezer with a clean dispos-
able towel.
sanitizing solution spray out the end of each
syrup line and the water line connector.
hopper inlet tube (figure 6-9), the drain tube,
the cylinder, and cylinder back wall (figure 6-
10), thoroughly with dish detergent solution.
Rinse using rinse bottle. Using sanitizing
solution, repeat brushing procedure making
sure all surfaces contact sanitizer.
Figure 6-10 Clean drain tube & cylinder
Replace worn brushes. Use only
Electro Freeze original or authorized
replacement parts. See Accessories
Parts List in Part II of this manual to
c. The shaft cup seal, washer, and
plunger O-ring grooves (figure 6-7).
d. The beater shaft and the scraper
blade pin holes, shown in figure 6-8.
e. The mixer shaft and bushing.
g. Mix chamber and tubes.
3. After all parts are washed, rinse and
Important:
4. Wash hopper walls and all soiled
5. Using the spray bottle filled with
6. Using proper brush, brush the
Drain Tube
order new brushes.
Cylinder
184592