ELECTRO FREEZE Compact Series Operator's Manual page 17

ELECTRO FREEZE Shake Model CS705
4 Part Names and Functions
The following part names and descriptions refer to figure 4-1.
1
2
3
4
5
6
7
8
9
10 O-RING - CHAMBER
11 HANDLE - ASSY COMPLETE
184592
COVER - ASSY FLEX SHAFT
Protects from accidental contact with
rotating shaft. Must be in place to oper-
ate.
O-RING - HEAD
Seals the head to the freezing cylinder.
Must be lubricated.
BUSHING - BEATER BEARING
Holds the beater in place at the front of
the cylinder. Must be inserted into the
head and lubricated before assembly.
KEEPER-ASSY SPINDLE
Secures the handle to the head.
HEAD - ASSY. W/RETAINERS 4 FLA-
VOR
Encloses the freezing cylinder and
provides an opening for product to be
dispensed.
QUICK CONNECT WITH SHUT OFF
Allows syrup line to be removed from the
mix chamber.
O-RING - SYRUP LINE
Prevents syrup from leaking.
SHAFT-ASSY MIX
Mixes flavor into shake mix.
CHAMBER- MIX
Delivers syrup to the shake mix.
Prevents mix from leaking. Lightly lubricate.
Opens and closes the plunger to start
and stop the flow of product from the
freezer.
— continued
12 O-RING - PIVOT POST
Holds the pivot post in place. Lightly lu-
bricate.
13 POST - PIVOT
Holds the handle in place.
14 PLUNGER-DISPENSING
Seals the product opening in the head
when closed. Allows product to flow
when open.
15 BUSHING-MIXER SHAFT
Holds the mixing shaft in place. Pre-
vents wear on plunger.
16 ROD-ACTUATOR
Starts the freezer when dispensing.
Must be in place before product can be
dispensed.
17 O-RING - PLUNGER-LOWER
18 O-RING - PLUNGER-LOWER
Seals the plunger in the head. Must be
lubricated to seal and slide properly.
19 SHAFT-FLEXIBLE W/CASING 16-1/2
Spins the mix shaft.
20 CONNECT-ASSY DRIVE
Quick connector used to connect or
disconnect the flexible shaft from the
mix shaft
7