Ipx Router To Bridge Configuration; Configuration For Site "Central - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

QUICK START
IPX R B
OUTER TO RIDGE
Using the IPX WAN Remote LAN feature provides easy set up for the network administrator,
especially if there are multiple remote sites.
FILESER1
Node # 0409A0111111
IN # 432109*
CSX5500
Phone # 13135551111
IN # 123456*
* IN # = Internal Network Number
C S
ONFIGURATION FOR ITE
The configuration on Central to allow IPX Routing to Remote using PPP is as follows:
1. Perform initial configuration
2. Under Options, select IPX Routing, then:
a. Enable IPX Routing.
b. Under IPX Internal Network Number enter the following value: 123456.
c. Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(0000BEEF).
d. Under IPX Interfaces add a WAN (Remote LAN) Interface and a hexadecimal IPX Network
Number (0000BEEF).
3. Under Security, select System Options and Information, then under System Information:
a. Set your System Name (Central). This matches up with Central device information
configured on Remote.
b. Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
6. Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a. Under ISDN Information select ISDN Line Protocol, then select PPP.
b. Under Authentication you must:
• Change CHAP Secret so that it matches Remote's System secret (Remote_S).
• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
c. Under Bridge Information you must make sure that Bridging is enabled
28 CyberSWITCH
C
ONFIGURATION
Network #0000BEEF
"Central"
"C "
ENTRAL
steps.
"Remote"
C A B L E T R O N S Y S T E M S
ISDN
CSX100
Phone # 13135552222