Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual page 36
Central site remote access switch
Hide thumbs
Also See for CyberSWITCH CSX5500:
- User manual (729 pages) ,
- User manual (178 pages) ,
- Release note (9 pages)
Table of Contents
Advertisement
QUICK START
Dialing Out
1.
Double click on your new dialing icon to bring up the Connect To screen.
2.
Enter your Remote for your user name and Remote_S for your password.
3.
Double click on Connect.
4.
Once the call is connected, click Details to view the type of protocols in use. Click Disconnect to
disconnect the call.
IPX R
D
OUTER WITH
C
S
ONFIGURATION FOR
ITE
The configuration on Central to allow IPX Routing to Remote is as follows:
1.
Perform
initial configuration
2.
Under Options, select the IPX protocol for the remote device, then:
a.
Enable IPX Routing.
b. Under IPX Internal Network Number enter the following value: 123456.
c.
Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(0130BABE).
3.
Under the Options menu, select Default Line Protocol. Increase the login timeout value to 45 or
50 seconds to accommodate the Digital Modem.
4.
Under Security, select System Options and Information, then under System Information:
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
b. Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
5.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
Under Digital Modem you must:
•
Select the line's bearer capabilities.
•
Enter the phone number for the device.
b. Under Authentication change CHAP Secret to match Remote's system secret (Remote_S).
c.
Under IPX Information you must ensure that IPX routing is enabled.
C
S
ONFIGURATION FOR
ITE
This section describes how to set up your remote-access Windows NT 4.0 location from which you
will be dialing. The process of configuring remote access networking for Windows NT involves:
•
installing a terminal adapter/modem
•
installing remote access networking
•
configuring a dial-out location
•
adding a dial-up entry
36
CyberSWITCH
M
T
IGITAL
ODEM TO A
"C
"
ENTRAL
steps.
"R
"
W
EMOTE
ON
INDOWS
A
/M
ERMINAL
DAPTER
NT 4.0
ODEM
Advertisement
Table of Contents
