Configuration For Site "Remote; Appletalk Router To Bridge Configuration; Configuration For Site "Central - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

C S
ONFIGURATION FOR ITE
The configuration on Remote to allow IPX Routing from Central using PPP is as follows:
1. Start QuickSET and select Custom.
2. Configure the CSX100 system information.
a. Accept the Local Ethernet IP Address. Click Next.
b. Set your CyberSWITCH Name (Remote) and System Password (Remote_S).
c. Select your switch type.
d. Enter the directory number for the CSX100 (13135552222). Click Next twice.
3. Define Central as a remote connection.
a. Click Add Remote, enter Central, and click OK.
b. Set the password. Click Remote's Password and enter Central_S twice for confirmation.
c. Define Central's phone settings. Enter 13135551111.
d. Optional: Define Caller ID Numbers if Caller ID Security was enabled. Click Next.
e. Enable Inbound and Outbound Bridging by clicking in the boxes.
4. Click Save.
A T R
PPLE ALK OUTER TO
MAC
CSX5500
"Central"
Central's AppleTalk Configuration
Network Range: 10-13
Zones:
Central.Engineering (default)
Central.Marketing
C S
ONFIGURATION FOR ITE
The configuration on Central to allow AppleTalk Routing to Remote is as follows:
1. Perform initial configuration
2. Under Options, select AppleTalk Routing, then:
a. Enable AppleTalk routing.
b. Under AppleTalk Port Information, configure a LAN port:
• Select the LAN port type.
"R "
EMOTE
B C
RIDGE ONFIGURATION
MAC
"C "
ENTRAL
steps.
Connecting a Central Site Product to a CSX100 via PPP
MAC
ISDN
Central Site Remote Access Switch
C
ONNECTIVITY
MAC
CSX100
"Remote"
C A B L E T R O N S Y S T E M S
29