QUICK START
A
T
R
PPLE
ALK
OUTER TO
MAC
CSX5500
"Central"
Central's AppleTalk Configuration
Network Range: 10-13
Zones:
Central.Engineering (default)
Central.Marketing
C
S
ONFIGURATION FOR
ITE
The configuration on Central to allow AppleTalk Routing to Remote is as follows:
1.
Perform
initial configuration
2.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
Under ISDN Information select ISDN Line Protocol, then select PPP.
b. Optional: If you wish to dial out to Remote, under ISDN Information you must enter a dial
out number and a base data rate (64Kb).
c.
Under Authentication you must:
•
Change CHAP Secret so that it matches Remote's System secret (Remote_S).
•
Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
d. Under AppleTalk Information you must:
•
Enter 0.0 for the AppleTalk address.
•
Enable AppleTalk Routing.
•
Enable making calls for AppleTalk data.
3.
Under Options, select AppleTalk Routing, then:
a.
Enable AppleTalk routing.
b. Under AppleTalk Port Information, configure a LAN port:
•
Select the LAN port type.
•
Enter lanport1 for the port name.
•
Enter 1 for the LAN port number.
•
Select the Extended network type (the default).
•
Enter 10-13 for the network range.
•
Accept the default of none for the suggested AppleTalk address.
•
Enter Engineering as the port's default zone name.
•
Enter Marketing as the second zone name.
22
CyberSWITCH
A
T
R
PPLE
ALK
OUTER
MAC
ISDN
"C
"
ENTRAL
steps.
C
ONFIGURATION
MAC
CSX1200
WORKGROUP REMOTE ACCESS SWITCH
"Remote"
POWER
SERVICE
Remote's AppleTalk Configuration
Network Range: 45-50
Zones:
Remote.Engineering (default)
Remote.Marketing
MAC
LAN
B-CHANNELS
E1 ONLY
B1
B3
B5
B7
B9 B11
B13 B15
B17 B19
B21 B23
B25 B27
B29
B31
TX
RX
10BASE-T
E1
T1
B2
B4
B6
B8
B10 B12
B14 B16
D
B18 B20
B22 B24
D
B26 B28
B30 L1