Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual page 37

Central site remote access switch
Hide thumbs Also See for CyberSWITCH CSX5500:
Table of Contents

Advertisement

Note:
Installing a terminal adapter/modem is not described in this document.
Install Remote Access Networking (first-time installation only)
To successfully negotiate and connect with the network, you need to set up protocols and network
services, as well as specify the system's identity:
1.
Open Control Panel and double click Network. Click Yes on the Network Configuration window to
invoke the Network Setup Wizard.
2.
Check the Remote Access to the Network box only. Click Next.
3.
In using remote access, you do not need a network adapter card. Leave the Network Adapters
section blank. Click Next.
4.
Check Unwind IPX/SPX Compatible Transport. Click Next.
5.
Netware Services may remain as listed. Click Next.
6.
Windows NT is now ready to install the network software. Click Next to begin installation.
7.
If necessary, give the path to your install diskettes or CD or where install files are located. Click
No on the TCP/IP Setup window. Click OK on any subsequent Setup Message windows you
may encounter.
8.
A set of remote access configuration windows are displayed:
a.
On the Add RAS Device menu, set RAS Capable Devices box to the modem you will use for
dial-up and click OK.
b. On the Remote Access Setup window, click Network, and enable IPX as your Dial out
Protocol.
c.
Options in the Configure menu may remain at default values. Click OK. Click Continue
when finished.
9.
The Network Bindings screen is displayed. Leave settings as-is; click Next to store binding
configuration.
10. At the ready to start network screen, click Next to start the network.
11. The next window identifies computer name, workgroup and domain. You may accept the
default membership to Workgroup, and leave Domain empty. Click Next.
12. Finally, you will be prompted to restart your system. Click Finish and Yes to reboot your
computer.
The system should restart and give you the opportunity to login as normal. Your remote access
service is now completely installed.
Connecting a Central Site Product to a Terminal Adapter/Modem
Central Site Remote Access Switch
C
ONNECTIVITY
37

Advertisement

Table of Contents
loading

Table of Contents