Connectivity; Overview; Connecting A Central Site Product To A Workgroup Product Via Ppp; Bridge To Bridge Configuration - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

C
ONNECTIVITY
O
VERVIEW
The Central Site CyberSWITCH can communicate with various other CyberSWITCH products via
a PPP connection. This connection can be used to transmit data and provide remote management
of your remote systems with Telnet, TFTP and SNMP. We will describe how to set up a PPP
connection with other CyberSWITCH systems, including the CSX100, and with a PC using a
terminal adapter or a modem. For these examples, we are assuming that CyberSWITCH "Remote"
is the remote system, and will want to call into CyberSWITCH "Central"; Central may or may not
want to call Remote.
C C
ONNECTING A
In this section, we describe the configuration steps required for connecting a central site system to
a workgroup system via PPP. Separate instructions are included for bridging,
UnNumbered
B B
RIDGE TO RIDGE
Server
Phone 13135551111
Configuration for Site "Central"
The configuration on Central to allow Bridging to Remote using PPP is as follows:
1. Perform initial configuration
2. Select Options from the main menu.
3. Select Bridging from the options menu, then ensure that bridging is enabled.
4. Select IP Routing from the options menu, then disable IP routing to allow timely bridging of IP
data.
S P
ENTRAL ITE RODUCT TO A
Interface, IPX routing, and
C
ONFIGURATION
CSX5500
"Central"
steps.
W
ORKGROUP
AppleTalk routing configurations.
WORKGROUP REMOTE ACCESS SWITCH
POWER SERVICE TX
Phone 13135552222
ISDN
P
RODUCT VIA
IP routing with an
CSX1200
"Remote"
LAN B-CHANNELS E1 ONLY
B1 B3 B5 B7 B9 B11 B13 B15 B17 B19 B21 B23 B25 B27 B29 B31
RX 10BASE-T
E1 T1
D D
B2 B4 B6 B8 B10 B12 B14 B16 B18 B20 B22 B24 B26 B28 B30 L1
PPP