Configuration For Site "Remote - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual
Central site remote access switch
Hide thumbs
Also See for CyberSWITCH CSX5500:
- User manual (729 pages) ,
- User manual (178 pages) ,
- Release note (9 pages)
Table of Contents
Advertisement
QUICK START
•
Enter lanport1 for the port name.
•
Enter 1 for the LAN port number.
•
Select the Extended network type (the default).
•
Enter 10-13 for the network range.
•
Accept the default of none for the suggested AppleTalk address.
•
Enter Engineering as the port's default zone name.
•
Enter Marketing as the second zone name.
c.
Under AppleTalk Port Information, configure a WAN (Remote LAN) port:
•
Select the WAN (Remote LAN) port type.
•
Enter Extended for Remote's network type (the default).
•
Enter 45-50 as the destination network range (Remote's network range).
•
Accept the default of none for the suggested AppleTalk address.
•
Enter Remote.Engineering as Remote's default zone name.
•
Enter Remote.Marketing as Remote's second zone name.
3.
Under Security, select System Options and Information, then under System Information:
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
b. Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
4.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
Under ISDN Information select ISDN Line Protocol, then select PPP.
b. Under Authentication you must:
•
Change CHAP Secret so that it matches Remote's System secret (Remote_S).
•
Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
c.
Under Bridge Information you must:
•
Make sure that Bridging is enabled
•
Enter the AppleTalk Network Number 45.
C
S
ONFIGURATION FOR
ITE
The configuration on Remote to allow AppleTalk Routing from Central using PPP is as follows:
1.
Start QuickSET and select Custom.
2.
Configure the CSX100 system information.
a.
Accept the Local Ethernet IP Address. Click Next.
b. Set your CyberSWITCH Name (Remote) and System Password (Remote_S).
c.
Select your switch type.
d. Enter the directory number for the CSX100 (13135552222). Click Next twice.
3.
Define Central as a remote connection.
a.
Click Add Remote, enter Central, and click OK.
b. Set the password. Click Remote's Password and enter Central_S twice for confirmation.
c.
Define Central's phone settings. Enter 13135551111.
d. Optional: Define Caller ID Numbers if Caller ID Security was enabled. Click Next.
e.
Enable Inbound and Outbound Bridging by clicking in the boxes.
4.
Click Save.
30
CyberSWITCH
"R
"
EMOTE
Advertisement
Table of Contents
