Configuration For Site "Remote - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

• enable IPXWAN protocol
• select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol
option
Note: By using triggered RIP/SAP, you do not need to configure static routes or services.
C S
ONFIGURATION FOR ITE
The configuration on Remote to allow IPX Routing to Central using PPP is as follows:
1. Perform initial configuration
2. Under Options, select IPX Routing, then:
a. Enable IPX Routing.
b. Under IPX Internal Network Number enter the following value: 456789.
c. Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(33333333).
3. Under Security, select System Options and Information, then under System Information:
a. Set your System Name (Remote). This matches up with Remote device information
configured on Central.
b. Set your System Secret (Remote_S). This matches up with Remote device information
configured on Central.
4. Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a. Under ISDN Information select ISDN Line Protocol then select PPP.
b. Under ISDN Information you must enter a dial out number (13135551111) and a base data
rate (64Kb) to dial out to Central.
c. Under Authentication you must:
• Change CHAP Secret so that it matches Central's System secret (Central_S).
• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
d. Under IPX Information:
• enable IPX
• enable Make Calls for IPX data
• enable IPXWAN protocol
• select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocol
option.
Note: By using triggered RIP/SAP, you do not need to configure static routes or services.
Connecting a Central Site Product to a Workgroup Product via PPP
"R "
EMOTE
steps.
Central Site Remote Access Switch
C
ONNECTIVITY
21