Heartland VALUE Series Assembly Manual page 5

ADDITIONAL MATERIALS FOR BUILDING YOUR SHED
3-TAB SHINGLES ............................. 5 Bundles
PAINT FOR SIDING .......................... 2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK ................................................. 2 Tubes
Use acrylic latex exterior caulk that is paintable.
• This shed kit does not include a wood floor frame or floor panels. See pages 10 through 14 for suggested floor construction.
• This shed does not include ANY leveling materials.
• See the FLOOR LEVELING section on page 8 for recommended methods and suggested materials to properly level your
floor, as this will vary depending on your specific site.
• See the CONCRETE FOUNDATION section on page 9 for recommended methods to build your shed on a poured concrete slab.
MATERIAL LIST:
x10
2 x 4 x 96" (5 x 10 x 243,8 cm) Treated Lumber
x2
2 x 4 x 144" (5 x 10 x 365,7 cm) Treated Lumber
x40
10D 3" (7,6 cm) Hot Dipped Galvanized Nails
MATERIAL LIST:
5/8 x 48 x 96" (1,6 x 122 x 243,8 cm) OSB Panels
x3
(Recommend 5/8" (1,6 cm) (minimum) thick OSB panels)
x186
6D 2" (5,0 cm) Hot Dipped Galvanized Nails
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT!
Depending on your specific use, you may want to construct a heavy
duty floor frame by adding additional floor joists. Below is a list in
addition to the framing materials above (not included):
x3
2 x 4 x 96" (5 x 10 x 244 cm) Treated Lumber
Cut to (3) 2 x 4 x 87" (5 x 10 x 221 cm)
x12
ea. 3" (7,6 cm) Hot Dipped Galvanized Nails
TO VALIDATE YOUR WARRANTY YOU MUST USE THE FOLLOWING:
DRIP EDGE ..................... 50 Feet
CAULK .............................................. 1 Tube
For windows use acrylic latex exterior caulk that is paintable.
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER'S INSTRUCTIONS FOR
FOUNDATION
WOOD FLOOR FRAME (NOT INCLUDED)
FLOOR PANELS (NOT INCLUDED)
INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
1" GALVANIZED ROOFING NAILS.... 3 Lbs
For shingles.
PAINT FOR TRIM ............................ 1 Quart
Use 100% acrylic latex exterior paint.
1" GALVANIZED ROOFING NAILS.........1/4 Lb
For roofing felt.
x10
x1
x1
#15 ROOFING FELT
To cover 134 Sq. Ft. of roof area.
3
Use Treated Lumber For
g
Floor Framin
CUT LIST:
2 x 4 x 87" (5 x 10 x 221 cm)
CUT LIST:
5/8 x 42 x 96" (1,6 x 106,7 x 243,8 cm)
5/8 x 48 x 90" (1,6 x 1221 x 228,6 cm)
Optional 12" (30,5 cm) spacing.