Heartland VALUE Series Assembly Manual page 38

PARTS REQUIRED:
Square the roof by installing one 48" x 96" panel at this time.
3
Use the panel's long edge as a lever to bring your roof into square.
Place the 48" x 96" roof panel as shown.
Use the gauge block to maintain 3/4" at rafter center (Fig. B).
Panel should be flush to lower roof panels.
Secure with (1) 2" nail in each corner.
4
At the outside edge, use the long edge of the panel as a lever.
Move the panel side-to-side until the outside long edge is overhanging the outer rafter by 5-7/8" (Fig E).
Secure with (1) 2" nail in each corner.
NOTE: Measurement from rafter edge.
5-7/8"
(14,9 cm)
Fig. E
ROOF PANELS
7/16" x 48 x 96"
(1,1 x 121,9 x 243,8 cm)
x1
Fig. B
3/4"
(1,9 cm)
Two Nails
Flush
5-7/8"
(14,9 cm)
3/4" GAUGE
BLOCK
Gauge
Block
Flush
5-7/8"
(14,9 cm)
36
x4
2" (5,1 cm)
48 x 96"
(121,9 x 244 cm)
Two Nails