BIANCHI VENDING BVM972 Use And Maintenance Manual page 56

Direct selection keyboard –Instant version
Test without sugar Performs an option drink without sugar
Complete test After pressing this key in line 2 the word Test
will be displayed and the machine will wait for
the selection; at the end of the preparation
the machine exits the test mode to go back
to maintenance mode.
Only water test In line 2 the word Test will be displayed and
the machine will wait for the selection The
selection will be made by setting all solubles
to zero, while the test of drinks with espresso
coffee is complete, at the end of the prepa-
ration the machine exits the test mode to go
back to maintenance mode.
Ground coffee test By pressing this key line 2 will display Ground
Test and the distributor will make a grinding
and then the dispenser will be released. In
this way the operator can check the grain size
and the basic weight of th ground dose.
Failure reset All alarms are set to zero and the diagnosis
of the Automatic distributor is performed.
Line 2 will show the Reset message for a T
of 2 seconds.
Mixer test Switches on the Mixers for 5 sec. in the fol-
lowing order 1,2,3,4,5,6
Group rotation Makes a rotation of the coffee group
Alarm scrolling
Used to scroll installed alarms and signallings.
In case of signallings, these are displayed
in line 2 as soon as maintenance mode is
accessed, in case of no signalling line 2 will
be blank. Visualization is not automatically
updated during the maintenance mode; to
update it this key must be pressed again.
Total selections The total unresettable selections are displayed
for a T of 2 seconds, then it is possible to
return to maintenance mode.
Spoon release Releases one spoon
Column rotation Allows column rotation
Cup Releases cup
1° FB cleaning 1° FB piston cleaning
2° FB cleaning 2° FB piston cleaning
Decount reset Allows to reset the decounters to the initial
value. A double pressing must be made.
MDB tube fi lling Filling MDB tubes
MDB tube depletion Coin 1 (key X depletes)
...
Coin 16 (key X depletes)
Micro switch test By pressing this key we will access the micro
switch test status. In this status by pressing
the micro switch to be tested, the master
board will provide a BEEP to confi rm its
operation.
56