4.5.4 Payment system installation
The distributor is supplied without any payment system:
The installation of the payment system is the responsibility of the
installation technician.
Bianchi Vending Group spa will not take responsibility for any
eventual damage to the machine itself and/or to things and/or
persons due to incorrect installation.
– open the board and coin mechanism protection door
4.21)
– Connect the payment system (Fig.4.22) to the Master board.
The selectors must be directly connected to the Master board
the and the serial executive systems through the interface cable
supplied with the machine.
Then go into programming for the correct settings.
Consult chapter" 5.0
SOFTWARE
setting of the parameters, that must be coherent with the system
used.
Check the payment system connections, by consulting the diagram
of the sheet shown.
– Hook the coin mechanism (Fig. 4.23).
INSTRUCTIONS" so as to verify
(Fig.
Fig. 4.21
Fig. 4.22
Fig. 4.23
23