BIANCHI VENDING BVM972 Use And Maintenance Manual page 20

4.4 Starting up of the unit
The distributor is equipped with a safety switch (Fig.4.9) that di-
sconnects the machine whenever the door is opened ( see electric
schema).
In case of necessity, therefore, open the door or disconnect unplug-
ging of the machine from the power supply.
The clamp of the power cable junction box remain
under tension (Fig.4.10-pos.1) as well as the servi-
ce switch inside the distributor. (Fig.4.11-pos.2).
– For some operations is however necessary operate with the
door open but with the distributor connected.
It is possible for installation technician, to operate in this way,
by inserting the special plastic key, supplied with the distributor,
into the door switch and rotating it 90° (Fig.4.12).
The opening and the possible connection with the distri-
butor's door open must be performed only by authorized
in carrying out these operations.
Don't leave the distributor open and unguarded.
Give the key only to qualifi ed personnel.
Any time the distributor is switched on there is a diagnosis cycle
to check the state of DA peripherals and perform the restoration
of moving parts.
Fig. 4.11
Fig. 4.9
Fig. 4.10
Fig. 4.12
20