BIANCHI VENDING BVM972 Use And Maintenance Manual page 22

At the end of the water fi l-
ling, effect a cleaning cycle
of the mixer group so as to
fi ll all the circuits and remo-
ve eventual residues from
the boiler (Fig.4.16).
Before connecting the power
supply, ensure that the
distributor has been con-
nected to the water mains
and that the water tap has
been turned on.
4.5.3 Cleaning of the parts in contact with
food substances
With distributor switched on
pressing the buttons according to what is described in the service
functions so as to eliminate any dirt from the coffee boiler and
the instant boiler.
– wash your hands carefully
– prepare an anti-bacterial cleaning solution with a chlorine base
(products that can be purchased in pharmacies) carefully fol-
lowing the indications on the product instruction labels.
– remove all the product containers from the distributor
(Fig.4.17)
– remove the lids from the product containers covers and product
chutes (Fig.4.18). Dip all in the solution previously prepared
– remove all the powder chutes, water funnels, mixing bowls
and whippers and silicone tubes and dip these parts also in
the prepared solution (Fig.4.18)
– with a cloth soaked with the solution clean the whipper assembly
base (Fig.4.20)
– the parts must soak in the solution for the time indicated on
the solutions' instruction label.
– Recover all the parts, rinse them abundantly, dry them perfectly
and proceed with the re-assembly in the distributor.
For further safety after the assembly of the parts, effect
some automatic cleaning cycles so as to eliminate any
eventual residues.
Fig. 4.16
effect a cleaning of the mixers
Fig. 4.17
Fig. 4.19
Fig. 4.20
22
Fig. 4.18