BIANCHI VENDING BVM972 Use And Maintenance Manual page 16

3.0 MOVING AN AUTOMATIC VENDING
MACHINE
3.1 Moving and transport (Fig.3.1)
The transport of the distributor must be effected by competent
personnel.
The distributor is delivered on a pallet; for the shifting use a trol-
ley and move it slowly in order to avoid capsizing or dangerous
movements.
Avoid :
– lifting the distributor with ropes or presses
– dragging the distributor
– upset or lay down the distributor during transport
– give jolts to the distributor
Avoid as the distributor:
– bumping it
– overloading it with other packages
– exposing it to rain, to cold or sources of heat
– keeping it in damp places
The construction company is not liable for any damage which
may be caused for the partial or complete non-observance of the
warning notices indicated above.
3.2 Stocking
For eventual stocking, avoid laying several machines over each
other, maintain it in vertical position, in dry places with tempera-
tures not inferior to 1°C (Fig.3.2).
3.3 Packing
The distributor is protected with polystyrene angles and by a
transparent fi lm in polypropylene (Fig.3.2).
The automatic distributor will be delivered packed, assuring both
a mechanical protection and protection against damages from
the external environment.
On the package labels are applied indicating:
maneouver with care
don't turn upside-down
protect from the rain
don't superimpose
protect from sources of heat
not resistant against bumps
type of distributor and serial number.
3.4 Reception
Upon reception of the automatic distributor you need to check that
the same has not suffered damages during the transport.
If damages of any nature are noticed place a claim with the
forwarder immediately.
At the end of the transport the packing must result without
damages which means it must not :
– present dents, signs of bumps, deformations or damages of the
external packaging
– present wet zones or signs that could lead to suppose that the
packing has been exposed to rain, cold or heat.
– present signs of tampering
3.5 Unpacking
- Free the distributor from the packaging , cutting the protective
fi lm in which it is wrapped, along one of the protection angles
(Fig.3.3).
- Remove the distributor from transport pallet, unscrewing the
screws (A) that block the fi xing cross staff heads to the pallet
(Fig.3.4).
190 kg
Fig. 3.1
Fig. 3.2
Fig. 3.4
16
Fig. 3.3