Installing The Microlan Modules - Cabletron Systems 9F122-12 User Manual

Enterasys mmac-plus 9f122-12 microlan module: user guide

Hide thumbs Also See for 9F122-12:

Table of Contents

Installing the MicroLAN Modules

SmartSwitch 9000 MicroLAN Modules can be installed in any of the 14 slots that

are available. To install, follow the steps below:

1. Remove the blank panel, covering the slot in which the MicroLAN Module

will be installed. All other slots must remain covered to ensure proper airﬂow

and cooling.

2. Unpack the MicroLAN Module by carefully removing it from the shipping

box. (Save the box and packing materials in the event the module must be

reshipped.)

3. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000

chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding

receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in

Figure 2-1.

4. Remove the MicroLAN Module from the plastic bag. (Save the bag in the

event the module must be reshipped.) Observe all precautions to prevent

damage from Electrostatic Discharge (ESD).

5. Examine the MicroLAN Module, carefully checking for damage. If any

damage exists, DO NOT install the module. Immediately contact Cabletron

Systems Technical Support.

6. Install the MicroLAN Module in the chassis by sliding it in any available slot

and locking down the top and bottom plastic tabs, as shown in Figure 2-1.

Take care that each module slides in straight and properly engages the

backplane connectors. When installing a module, ensure that the circuit card

is between the card guides, as shown in Figure 2-1. Check both the upper and

lower tracks.

Chapter 2

2-1

Table of Contents