Cabletron Systems SmartCell 6A000 User Manual page 27

Switch Installation and Setup
: Start a process on the switch; for example, start the LAN Emulation Configuration Server.
start
: Restart a process on the switch; for example, restart a client.
restart
: Remove assigned values; for example, flush a route table.
flush
: Create easier names for often-used commands and their parameters.
alias
Entering parameters at the command line is optional. If a command requires parameter values, it prompts you for them.
For instance, in the example below,
indicating that you want to show configuration information about port
SmartCell ZX # show portconfig a1
==================================================
Port: A1
--------------------------------------------------
Parameter
--------------------------------------------------
Sig Type
Sig Role
Interface Type
Max vpi bits
Max vci bits
Max SVC vpci
Min SVC vci
Max Vccs
--------------------------------------------------
Other parameters
--------------------------------------------------
Port Admin Status
Ilmi Admin Status
Oper State
Trans Type
Media Type
Bandwidth
SmartCell ZX #
If you don't specify parameters with the command, the console prompts you for an input value and provides a default
value displayed in parenthesis. For example, if you enter
the following appears. Here, the default of "
or you can enter a specific port number. Taking the default displays the following:
SmartCell ZX # show portconfig
PortNumber(ALL)
Port Intf Sig
ID Type Type
==============================================================================
A1 private pnni10
A2 private autoConfig
A3 private autoConfig
A4 private autoConfig
B1 private autoConfig
B2 private autoConfig
B3 private autoConfig
B4(CPU) private uni31
C1 private autoConfig
C2 private autoConfig
C3 private autoConfig
C4 private autoConfig
D1 private autoConfig
D2 private autoConfig
D3 private autoConfig
D4 private autoConfig
SmartCell ZX #
is the operator,
show
Configured Current
autoConfig pnni10
other symmetric
private private
0 0
12 12
0 0
32 32
4096 4096
UP
Enabled AddressRegistration Connectivity
UP
STS-3c
MMF (S)
155 MB
" ports is presented. You can either accept the default by pressing Enter,
all
:
Trans Media
Type Type
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c SMF (I)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c MMF (S)
STS-3c CAT5 UTP
STS-3c CAT5 UTP
STS-3c CAT5 UTP
STS-3c CAT5 UTP
is the switch-attribute, and
portconfig
.
A1
without specifying a port (as a parameter),
show portconfig
Speed Oper
(MB/s) State
155 MB UP
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB UP
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
155 MB DOWN
Using the Console
is the parameter
a1
SmartCell 6A000 User Guide 2-9