Table of Contents
Advertisement
C o n f i g u r a t i o n V i e w s
Table 24: Received Technology Values
Received
Value
Technology
Undefined
1
Auto-
2
Negotiation
Not-Detected
4
10Base-T
8
10Base-TFD
16
100Base-TX
32
100Base-TXFD
64
100Base-T4
128
100Base-FX
256
100Base-FXFD
512
Repeater Configuration View
Access:
From the Chassis Device view highlight the
appropriate Repeater label on the Chassis Module icon,
from Icon Subviews menu, the select the Repeater
Configuration.
The Repeater Configuration view provides
information on the configuration and operating
S p e c t r u m E n t e r p r i s e M a n a g e r
Description
Undefined
Auto-Negotiation/Parallel
Detection
Link Partner does not support
Auto-Negotiation
10Base-T
Full duplex 10Base-T
100Base-TX
Full duplex 100Base-TX
100Base-T4
100Base-FX
Full duplex 100Base-FX
status of the selected repeater interface. This view
is divided into the four areas described below
(Repeater Management, Trap Management,
Alarm Configuration, and Error Source).
Repeater Management
This area of the Repeater Configuration view
provides the port information described below.
Port Count
Displays the total number of ports on this LAN
segment.
Ports On
Displays the total number of ports currently in
the ON state on this network.
Ports Operational
Displays the number of operational ports on this
network.
Network Ports
Allows you to enable the network ports on this
network segment. Possible states are: "NoEnable"
and "Enable".
Page 56
R e p e a t e r C o n f i g u r a t i o n V i e w
S m a r t S w i t c h 6 0 0 0
Advertisement
Table of Contents
