Cabletron Systems 1082 User Manual page 52

C o n f i g u r a t i o n V i e w s
Max VCI (Virtual Channel Identifier) Bits
The maximum number of active VCI bits
configured for use at this ATM interface.
ILMI (Interim Local Management Interface) VPI
The VPI value of the VCC supporting the ILMI at
this ATM interface. If the values of both ILMI VPI
and ILMI VCI equal 0, then the ILMI is not
supported for this ATM interface.
ILMI VCI
The VCI value of the VCC supporting the ILMI at
this ATM interface. If the values of both ILMI VPI
and ILMI VCI equal 0, then the ILMI is not
supported for this ATM interface.
Address Type
The type of primary ATM address configured for
use at this ATM interface.
Admin Address
The address assigned for administrative
purposes. If this interface has no assigned
administrative address or if the address used for
administrative purposes is the same as that used
for the physical address, then this is an octet
string of zero length.
Neighbor Address
The IP address of the neighbor system connected
to the far end of this interface to which a Network
S p e c t r u m E n t e r p r i s e M a n a g e r
A T M C l i e n t C o n f i g u r a t i o n V i e w
Management Station can send SNMP messages as
IP datagrams to UDP port 161 in order to access
network management information concerning the
operation of that system.
Neighbor If Name
The name of the interface on the neighbor system
at the far end of this interface, and to which this
interface connects. If the neighbor system is
manageable through SNMP and supports the
object ifName, the value of this object must be
identical to that of the ifName for the ifEntry of
the lowest level physical interface for this port. If
this interface does not have a name, the value of
this object is a zero length string.
Page 53 S m a r t S w i t c h 6 0 0 0