Preparation For Modeling; Modeling Using The Chassis Ip - Cabletron Systems 1082 User Manual

M o d e l i n g
Figure 18: Chassis Container View
Primary Landscape 0x00400000 - VNM Host -
* File View
Model One
6E122_26
Model Four
6H202_24
S p e c t r u m E n t e r p r i s e M a n a g e r
Help
Model Three
Model Two
6E138_25 6E233_49
Model Five
6H122_16

Preparation for Modeling

Before modeling the chassis, you should be
familiar with the process of creating models and
accessing views. Refer to Getting Started with
SPECTRUM for Administrators and How to
Manage Your Network with SPECTRUM for
instructions. You should also be familiar with any
network management and firmware requirements
described in the 6C105 chassis firmware
documentation.
For proper modeling, the chassis and its
installed modules must not be in Mixed
Management mode. Each module should
Caution:
Caution: have its own IP address or the chassis
should be configured with a single IP
address.

Modeling Using the Chassis IP

The chassis model can only be place in a Room
Location view. The Room Location view is created
by starting at the Universe level view and navigate
into the Room Location level, as described below.
At the Universe level, select View > New View
1
> Location.
This places you at the top level of the Location
views.
Page 63
P r e p a r a t i o n f o r M o d e l i n g
S m a r t S w i t c h 6 0 0 0