Table of Contents
Advertisement
C o n f i g u r a t i o n V i e w s
Error Alarms
Allows you to enable or disable detection of Error
Alarms. Possible menu selections are: Enable and
Disable.
Error Threshold
Displays the threshold value for the percentage of
errors per good packet that may occur within the
Timebase before generating an error alarm. This
value is user-configurable from 1 to 100.
Error Source
This area of the Repeater Configuration view
provides a series of buttons that let you select the
types of errors to include in the error sum. The
selectable error types are as described below.
CRC
Packets with bad Cyclical Redundancy Checks.
Runts
A packet that is one byte less than the standard
Ethernet frame of 64 bytes (not including
preamble).
OOW_Colls
Collisions out of the standard window due to a
network problem.
Alignment
Misaligned packets detected.
S p e c t r u m E n t e r p r i s e M a n a g e r
No_Resource
The number of times the module ran out of
resources (i.e., lack of buffer space) and could not
accept packets.
Giants
Packets received that exceed 1518 bytes (not
including preamble).
Ethernet Based Configuration
Access:
From the Chassis Icon, select Ethernet Based
Configuration.
This view provides port configuration information
for GPIM models. This view also shares fields with
the
Fast Ethernet Configuration View (page 54)
and the shared fields are covered there. The fields
below detail the device specific information found
with this view.
Auto Negotiate Mode
Indicates whether Auto-Negotiation is enabled for
a specific port. If Auto-Negotiation is disabled the
port will revert to the speed, duplex, and flow
control settings specified by their associated
leaves in the Flow Control groups.
Remote Auto Signal
Indicates whether the remote end of the link is
operating in Auto-Negotiation signaling or not.
Page 58
E t h e r n e t B a s e d C o n f i g u r a t i o n
S m a r t S w i t c h 6 0 0 0
Advertisement
Table of Contents
