Interface Labels - Cabletron Systems 1082 User Manual

D e v i c e V i e w s

Interface Labels

These labels represent the interfaces located on
the front panel of the module. Each label provides
access to an Icon Subviews menu, which contains
the following three device-specific selections:
• Operational Mode Configuration allows you
to set the interfaces operational mode to
either Standard or Full Duplex.
• Enable and Disable allow you to control the
port's operational status.
Each Interface label displays two information
labels: an Interface Type label and an Interface
Status label.
Interface Type Label
This label identifies the type and number of the
interfaces represented. For example, "e1" refers to
Ethernet interface number one for that module.
Interface Status Label
This label indicates the interface's operational
status relative to the application using the colors
and legends listed in
Application Label (page 24)
selecting the application to be displayed.
S p e c t r u m E n t e r p r i s e M a n a g e r
Table 6 and Table 7. See
for information on
Table 6: Bridging Application Interface
Color Status
Green FWD
Blue DIS
Magenta LST
Magenta LRN
Blue SBY
Orange BLK
Red BRK
Blue UNK
Table 7: Physical Application Interface Status
Color Status
Green ON
Blue OFF
Yellow TST
Page 25
C h a s s i s D e v i c e V i e w
Status
Description
Bridge port is forwarding.
Port is disabled.
Bridge is in the listening mode.
Bridge is in the learning mode.
Bridge port is in the standby
mode.
Bridge port is in the blocking
mode.
Bridge port is broken.
The status is unknown.
Description
Port is operational.
Port is off.
Port is in the test mode.
S m a r t S w i t c h 6 0 0 0