Table of Contents
Advertisement
M o d e l i n g
See Positioning the Chassis Device Icon,
7
below, to properly locate the automatically
created chassis Device icon.
Positioning the Chassis Device
Icon
Some of the modeling procedures described above
automatically create a chassis Device icon. This
icon can be copied into a Room Location view.
Create a Room Location view using Steps 1
1
through 10 in
Modeling Using the Chassis IP
(page
63).
To locate the chassis Device icon, activate the
2
Topology view and select View > New View >
Find.
Copy the chassis Device icon into the Room
3
Location view as follows:
Within the Find view, select File > Edit.
a
Select 6C105.
b
From the Edit menu, select Copy.
c
Access the Room Location view and select
d
File > Edit to enter the Edit mode.
Select Paste.
e
The icon appears in the Room Location view.
S p e c t r u m E n t e r p r i s e M a n a g e r
M o d e l i n g U s i n g t h e C h a s s i s I P
Exit the Edit mode.
f
Page 66
S m a r t S w i t c h 6 0 0 0
Advertisement
Table of Contents
