What Is Hott 7P; Battery Installation - GRAUPNER HOT TG/mz-12 Operating Instruction

9
Assemble the centering cam into the
throttle gimbal of mode 1 transmitter and set
the spring in the center control part and the
centering cam with tweezers
Tension spring
Assemble the transmitter's rear case and switch to mode 2 from mode 1 at Stick mode page in
the transmitter programming setup section according to the manual.
NOTICE
Make sure to test all functions are normally operated in mode 2 before flying
10
Screw the disassembled tension con-
trol bolt from the elevator gimbal of mode
1 transmitter into the throttle gimbal and
adjust the bolt for the desired control
10. WHAT IS HoTT
HOPPING TELEMETRY TRANSMISSION(HoTT)
it is Graupner/SJ's unique telemetry technology in
2.4GHz signal protocol that support Bi directional
data transmission gives user real-time information on
things like user model's RPM, Voltage, Temperature,
User programmed warning, and etc. The use of up to
75 channels ensures extreme operating reliability and
immunity to external interference thanks to optimized
frequency hopping broad channel sequence.

11. BATTERY INSTALLATION

Optional NiCd or NiMH 1.2-volt AA rechargeable 4-cell batteries can be used. A battery connecter
is on the inside of the transmitter for convenient recharging. Graupner/SJ offers rechargeable
NiCd, NiMH batteries, part number S22331.
Remove the battery cover and install the battery pack
ensuring the polarity of the battery connecter.
CHARGING BATTERIES
The included charger is designed to recharge your batteries at a rate of 150mA. Do not use this charger
for equipment other than Graupner/SJ transmitters that use 4-cell battery packs. The charging plug
polarity may not be the same and equipment damage can result. During the charging operation, the
charger's temperature is slightly elevated. This is normal.
CAUTION
Charge only rechargeable batteries. Non-rechargeable
batteries may burst causing injury to persons and/or dam-
age to property. Never leave charging batteries unattended.
The mz-12 is compatible with all current Graupner/SJ Aircraft receivers ( R Series )
Graupner/SJ
Transmitter Charge Jack Polarity
7