GRAUPNER HOT TG/mz-12 Operating Instruction page 26

5. D/R expo (Aircraft and Helicopter)
The basic setting of the Helicopter cont sett is NO.5 gyro, NO6. Throttle, Lim. DV (Digital volume).
Generally, this function is seldom used, but Lim. DV (Digital volume) can control the operation range
of digital volume -100 ~ +100. If DV is programmed, throttle channel is operated only programmed
range.
- D/R
Affects the overall travel which in turn affects control response sensitivity equally throughout the
range of that channel. Reducing the dual rate reduces the maximum control rate as well as overall
sensitivity.After programming the max moving angle of the servo at the servo sett function, the D/R
switch is ON, the basic value of the normal flight can be programmed. Depending on the D/R switch
is on/off, the Aircraft to have a high control rate for aggressive maneuvers and a low control for
smooth, precise maneuvers.
- Expo
Affects the sensitivity around center but has no affect on the overall travel. Positive Exponential
reduces control sensitivity around neutral for more precise control but does not affect the maximum
control response. Negative exponential increase control sensitivity around neutral.
- D/R expo
Press the direction button to highlight the D/R expo then press the ENT button to access the function.
The cursor is at the dual value of the aileron channel. Press the ENT and the directions button to
highlight and adjust the desired value then press the ESC and the direction buttons to select the expo
value in the aileron channel. Press the ENT and the direction buttons to highlight and adjust the desired
value then the press the ESC and the direction button to select the hyphen. Press the ENT button then
the pop up message "push desired switch into position on" appears. Move the switch that you want to
assign as the dual on/off . That switch is assigned to the aileron dual on/off switch.
NOTE : If the quick link switch is ON when the quick link function is activated, the dual value can be
programmed to go with the purpose of the quick link The elevator and rudder channels can be program
in the same method with the aileron channel.
26
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
press
press
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC