Fail Safe (Aircraft And Helicopter) - GRAUPNER HOT TG/mz-12 Operating Instruction

12. Fail safe (AIRCRAFR and Helicopter)
When you bind your transmitter, you are programming the receiver with failsafe defaults. If con-
nection is lost between the transmitter and receiver, the receiver immediately operates in those
preprogrammed default positions. Graupner/SJ receiver has 2 failsafe modes, hold and Pos
(Position/Fail Safe)
- Hold
If you lose connection between the transmitter and the receiver, all channels hold the last given
command.
- F/S
If the signal is lost, all channels are driven to their failsafe preset position during binding.
Press the direction button to highlight the fail safe then press the ENT button to access the func-
tion. The black dot is on the NO.1 channel indicating NO.1 channel is selected and the Hold (the
default mode) is assigned. Press the direction button to select the channel and press the ENT
button to select the F/S or the hold. After completing to select the desired mode in all channels,
press the direction button to select the Delay. Press the ENT button to highlight the value then
press the direction button to adjust the desired value. Press the ESC button to highlight the STO.
Move the stick to the desired position then press the ENT button. The popup message "position
stored" appears (the F/S function is operated at that stick position). Confirm the failsafe setting is
correct by turning off the transmitter.
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
press
press
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
51