GRAUPNER HOT TG/mz-12 Operating Instruction page 74

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20
cm between the radiator and your body.
KC Information
- Graupner /SJ mz-12 Transmitter
- KCC인증번호: KCC-RRM-sjr-16005100, KCC-CRM-sjr-36204210
- 방송통신위원회고시 제2013-01호 "무선설비규칙"
- 방송통신위원회고시 제2012-102호 "신고하지 아니하고 개설할 수 있는 무선기기"
-KN 301 489-1:2009
-KN 301 489-17:2009
-KN 61000-4-2:2008
-KN 61000-4-3:2011
74
Caution
• This equipment's aerial must be at least 20 cm from any person when the system is in use. We
therefore do not recommend using the equipment at a closer range than 20cm.
• Ensure that no other transmitter is closer than 20cm from your equipment, in order to avoid
adverse effects on the system's electrical characteristics and radiation pattern.
• The radio control system should not be operated until the Country setting has been set correctly
at the transmitter. This is essential in order to fulfill the requirements of various directives -
FCC, ETSI, CE, KC and etc. Please refer to the instructions for your particular transmitter and
receiver for details of this procedure.
• Check all working systems and carry out at least one full range check on the ground before
every flight, in order to show up any errors in the system and the models programming.
• Never make any changes to the programming of the transmitter or receiver whilst operating a
model.
ENVIRONNEMENTAL PROTECTION NOTES
This product must not be disposed of with other waste. Instead,
it is the user's responsibility to their waste equipment by handing it over to
a designated collection point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of
your waste equipment at the time of disposal will help to conserve natural resources and ensure
that it is recycled in a manner that protects human health and the environment. For more infor-
mation about where you can drop off your waste equipment for recycling, please contact your
local city office, your household waste disposal service or where you purchased the produce