GRAUPNER HOT TG/mz-12 Operating Instruction page 66

press
press
press
66
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
CH OUT TYPE
ESC
You may decide the signal output type of receiver. 5 types of ONCE / SAME / SUMO12/ SUMI /
SUMD HD12 are available.
- ONCE
It is use for analogue servo. If ONCE is selected, PERIOD on RX SERVO is set to 20msec auto-
ENT
matically.
TEL VIW
- SAME
ESC
It is use for digital servo. If SAME is selected on CH OUT TYPE line, you need to set PERIOD on
RX SERVO to 10 ~ 20msec. when analogue servo is used, 20mse should be set.
- SUMI
press Receiver get the signal of the receiver performed the SUMO programming setup then outputs the
signal
ENT
- SUMD HD
The digital output signal of all channels in receiver is outputted from the selected channel.
TEL VIW
It is used to the product that needs the receiver digital signal such as Power box and Flybarless
ESC
system. The factory default for SUMD HD output channel is the last channel of receiver and you may
change it.
- SUMO
Only the selected channel outputs the signal of all channels of receiver. In case that 1 receiver is
set to SUMO and the other receiver is set to SUMI and then they are connected in ex code, the
ENT
receiver set to SUMI outputs the signal came from the receiver set to SUMO. The final channel of
TEL VIW
receiver is set to SUMO output channel, but you may change to the desired channel.
ESC
Press DOWN buttons to access CH OUTPUT TYPE and press ENT button then the default value
SAME is highlighted. Press UP/DOWN buttons to set the desired value and press ENT button to
remove the highlight. When you select SUMO 12 and SUMD HD12 and try to select the different
output channel, press ENT button to move the highlight to 12 then press UP/DOWN button to select
the desired channel. Press ENT button to remove the highlight.
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC