Total Stop - Bomar Ergonomic Automat Series Operating Instruction

1.4.
1.5.
1.5.1.
1.5.2.
12
•
Use the protective instruments for chips removal!
Safety notes for the servicing and repairs
Attention!
Only a qualified professional can carry out the servicing
and repairs of the electric equipment! Take special care
during the work with electrical equipment. High voltage
shock can have fatal consequences! Always keep notes
about work safety! Otherwise, there is possibility of heavy
injury!
Switch off the main switch and lock it, before you start service work! Otherwise,
there is possibility of hazardous machine starting.
Only qualified person can do the servicing and repairs. For parts changing, use
only parts, which are identical with the originals. Otherwise, there is possibility
of health hazard. Use only recommended type of the hydraulic oils and oils
and lubricants!
Do not remove or do not lock the limit switches or safety equipments! Any use
of the saw, accessories or machine parts other than that intended by the
BOMAR, spol. s r.o. company is not permitted. The guarantee on this product
will be afterward lost and BOMAR, spol. s r.o. takes no responsibility for
caused damages.
Safety machine accessories
The machine is equipped with safety accessories. It protects the operator from
injuries and the machine before damage. The safety accessories are blocking
accessories, emergency switches and covers. Check once in a week the
function of the safety accessories. If the safety accessories are functionless,
you must stop work and repair or change the safety accessories.
Enhanced risk!
Do not come into or intervene in the cutting area.
Otherwise, there is possibility of heavy injury.
TOTAL STOP button
TOTAL STOP button is used for emergency switching – off the machine in
case defect or health hazard. By pressing TOTAL STOP button is interrupted
the supply of the electrical power.
If any damages or fault appears, immediately press TOTAL STOP button!
Release the pressing button is possible by twisting of the upper part of the
button.
Saw arm cover
If the cover is opened during operation, the limit switch is opened and the band
saw is stopped. The band saw is not possible to start in set mode.
The band saw is stated to the operation, when the cover is closed!
Manual version: 1.02 / Mar. 2010
Manual rev.: 1